The Makino DA300 5-Axis Vertical Machining Center combines a rigid structure and high dynamic motion control to significantly reduce part cycle times while maintaining very accurate performance.  Equipped with an integral, DD – motor designed A – Axis and C – Axis, the machine provides five – side access for single set-up production of complex production parts.

At 20,000 RPM, 29.5 HP, HSK–A63, the machine spindle provides the capability to tackle rigorous milling, drilling and tapping tasks associated with a wide variety of production parts.  A standard, 60 tool magazine insures an extensive selection of tooling to address any part configuration.

To further minimize non – cut times, the DA300 is standardly equipped with a Vision BTS (Broken Tool Sensor) outside of the machine work zone to insure tooling integrity – but, not impact part cycle times.

The DA300 integral table rectangular table (340 mm x 300 mm) is prepared with pneumatic ports design to readily integrate into a pallet system providing for quick, efficient part exchange – maximizing machine utilization.
 
The Makino Professional 6 control takes you from parts to profits with elegant functionality by making the point where human meets machine a seamless transition.  Streamlined screen layouts, operator assistance, new machine functions, and safety enhancements are accelerating and protecting your productivity.  For even greater productivity, Super Geometric Intelligence 5 (SGI.5) insures optimum performance during execution of the tool path – producing the shortest cycle times.
 
Standard Features:

• Sixty (60) Tool Magazine
• 20,000 rpm, 2 range, HSK–A63 Spindle
• Automatic Spindle Lubricant Temperature Controller
• Tilt-Trunion Table (A & C axes)
• Integral Table (13.4” x 11.8”)
• Machine temperature control:
  • “Core Cooled” Ballscrews
  • Support bearing & drive motor
  • A & C Axes DD Motors
• Vision BTS
• Automatic Lubrication Supply Unit
• Base Coolant
• Nozzle Coolant
• 210psi Through Spindle Coolant
• Overhead Shower Coolant
• Right Discharge LUCC
• Splash and Chip Shield
• Makino Professional 6 Control
• Makino Proprietary Super Geometric Intelligence SGI.5 Software
• Data Center (1 GB)
• Part Program Storage (2 GB)
• Tool Offset Pairs (400 Total)
• Rigid Tapping
• Rigid Tap Retract Function 
• Five Axis Software:
  • TCP – Tool Center Point Control 
  • DFO – Rotary Table Dynamic Fixture Offset
  • TWP – Tilted Work Plane Command
  • Three Dimensional Cutter Compensation
  • Inversed Time Function
  • Program Restart
  • 3-Dimensional Manual Feed;
  • Spindle-Table Interference Prevention Function
  • Collision Safeguard
• Custom Macro (1,100 variables)
• Helical Interpolation
• Portable MPG
• Air Dryer
• Maintenance Advice System
• Inch/Metric Selection
• Fluorescent Worklight
• Programming Data Input (G10)
• Spindle Load Display
• Spindle Load Monitoring
• Tool Life Management
• Direct Spare Tool Selection
• Dual Safety Check
• Signal Light (3 layer)6